Round LED Mini Switch

SKU: OZ01853
VN:F [1.9.22_1171]
Product Quality
Energy Efficiency
Light Factor
Easy of use
Price Factor
Customer Service
Rating: 3.6/5 (2 votes cast)
12V LED productRoHS compliant LED productLED Light switches on instantly to 100% in zero secondsNext day delivery

Round LED Mini Switch

Small and neat LED indicator switch that fits into 20mm round hole and indicates switch status through little LED. For your convenience, the switch comes pre-wired with about 15cm of wire crimped on.

This LED product is out of stock or has been discontinued and replaced by a new product with an upgraded design and functionality. If you are interested in purchasing this particular item, please contact our customer support.
Oznium Light Factor 5

Technical Specification

Productsheet for <?php the_title(); ?>
Base type
Plastic with 3-pin
Power consumption
16Amp rating
Voltage
250V
LED working temperature
max 30C
Certificate
RoHS
Lifespan
30,000 cycles

Product Description for Round LED Mini Switch

This simple but effective switch with a load capacity of up to 16 Amps will make you switch – a lot! Super easy installation as it snaps into a 20mm hole and you are good to go.

The Oznium illuminated mini switch is your must have switch for your garage and workshop, and is the perfect over-ride switch for any LED light circuit using our day night sensor switch.

Wiring Instructions: Very easy to wire. Click on the last two pictures above to see wiring diagram for 1 or 2 strip lights. The black wire is connected to ground, the red wire in the middle to constant power source (live) and the other red wire (load) to the LED light circuit that you are powering. If you have any further questions, contact our customer support for help.

Available in the following variations:

  • Blue (LED lights up when switch is on)
  • Red (LED lights up when switch is on)
  • Green (LED lights up when switch is on)
  • White (LED lights up when switch is on)

 

Frequently Asked Questions

With the LED lighted switches, is there a way to put a resistor on the feed to the LED to reduce the intensity of the light 'glow' for night operation? Yes, putting a resistor on the feed to the LED will reduce the intensity.

The switches say they are rated at 10A 120V AC. I just want to be sure that these will work on a 12V DC circuit. Absolutely! Nearly 100% of our customers use these switches on 12V DC circuits.

Do you attach the ground wire to a bare metal spot on the chassis of the vehicle, or do you attach it to the negative post on the battery? Either will work. Because the negative post on the battery is essentially connected to the metal throughout the car, it all has electrical continuity.


1 Customer Review


  1. Charles Wynberg

    6 years ago

    Using this round switch as on/off switch on an exterior power socket in the garden – quiet nice to have the blue LED light on especially when its dark so one can see around the socket outlet.

    Super easy wiring – took me 5 minutes to install

    Reply

Write your own Customer Review